Glassworking

• Glass Batches
• Lime & Potash
• Glassworking Tools
• Blowpipe
• Paddle
• Jacks
• Gem Saw
• Glassworking Steps
• Table Pour
• Basin Pour
• Glass Coloring
• Dye List

Introduction

ガラス加工とは、砂を原料にしてガラスを作る工程です。まずはガラスバッチを用意する必要があり、次の4種類があります：

1. シリカ：白い砂
2. 赤鉄鉱：黄色・赤・桃色の砂
3. かんらん：緑・茶色の砂
4. 火山：黒い砂

Silica Glass Batch

Glass batches can then be crafted using one of the aforementioned colors of sand, plus Lime and a type of Potash.
Remember that different sand types can be obtained by breaking gravel with a hammer.

Soda Ash or Saltpeter can be used as a source of Potash. Soda ash is a powder made from heating Dried Seaweed or Kelp.

Lime is produced by heating Flux.

Tools of the Trade

Glassworking is done by starting with a glass batch, and then completing a series of steps. These steps may require specific tools:

• A Blowpipe, to Blow and Stretch.
• A Paddle, to Flatten.
• Jacks, to Pinch.
• A Gem Saw, to Saw.
• And a Wool Cloth, to Roll.

The most important tool is the Blowpipe. An Unfired Ceramic Blowpipe can be knapped from clay, and then fired into a Ceramic Blowpipe.
However, ceramic blowpipes are brittle, and have a chance to break when used. An invulnerable Blowpipe can be Worked from a Brass Rod on an anvil.

Paddle

平らにする工程は、木材で作れる木ごてを使って行います。

The Pinch operation can be done with Jacks, made from Welding a brass rod with a brass plate.

Gem Saw

The Saw operation can be done with a Gem Saw. The gem saw is also used to break both Glass Blocks and Glass Panes to obtain them.

How to Work Glass

First, glass on the blowpipe must be heated to at least Faint Red. Then, hold the blowpipe in your offhand and hold Right Click to perform each step.
Use F to pick up a hot blowpipe into your offhand.

Blow
Use the Blowpipe while facing straight ahead.

Stretch
Use the Blowpipe while facing straight down.

Flatten
Use the Blowpipe while holding a Paddle in your main hand.

Pinch
Use the Blowpipe while holding Jacks in your main hand.

Saw
Use the Blowpipe while holding a Gem Saw in your main hand.

Roll
Use the Blowpipe with a Wool Cloth in your main hand.

Table Pour

Glass Panes are made with a Table Pour. A pouring table is made by placing up to sixteen Kaolin Clay Blocks or Brass Plated Blocks in a continuous area.

1. Add a Glass Batch to a Blowpipe.
2. Heat the blowpipe to Faint Red.
3. Right Click the Blowpipe on the top of the table.
4. Finally, Right Click with a Paddle to flatten the glass.

Basin Pour

Glass Blocks are made with a Basin Pour. A basin is made by surrounding all sides of an air block except the top with Kaolin Clay Blocks or Brass Plated Blocks.

1. Add a Glass Batch to a Blowpipe.
2. Heat the blowpipe to Faint Red.
3. Right Click the Blowpipe on the top of the table.

ガラス精製用のブロック

ガラスの染色

Glass has a natural color based on the type of Glass Batch that was used. Other colors can be made using a Bowl.

To use, place the Bowl on the ground, then Right Click the required Powder. Before Pouring, use the Blowpipe on the bowl to add the powder to the batch.

Dye Colors

• 白色：シリカまたは赤鉄鉱ガラス + ソーダ灰
• 黒色：任意のガラス + 黒鉛
• 灰色：任意のガラス + 黒鉛 + ソーダ灰
• 薄灰色：任意のガラス + 黒鉛 + 2x ソーダ灰
• 紫色：任意のガラス + 鉄 + 銅
• 茶色：任意のガラス + ニッケル
• 青緑色：火山ガラス以外 + 銅 + サファイア
• 緑色：シリカまたは赤鉄鉱ガラス + 鉄

• 黄緑色：シリカまたは赤鉄鉱ガラス + 鉄 + ソーダ灰
• 水色：シリカガラス + ラピスラズリ
• 青色：シリカガラス + 銅
• 赤色：シリカまたは赤鉄鉱ガラス + スズ
• 黄色：シリカまたは赤鉄鉱ガラス + 銀
• 橙色：シリカガラス + 黄鉄鉱
• 赤紫色：シリカまたは赤鉄鉱ガラス + ルビー
• 桃色：シリカガラス + 金
• 遮光：シリカガラス以外 + アメジスト

ガラス着色の可否表

ガラスの色には作成できる条件があります。「C」は透明なガラス、「T」は遮光ガラスを表しています。なお、それぞれの色は対応したガラスバッチでしか作れません。

---